TSS type TRE and Stefa type CC - TREA01600-VCV

Type TRE are seals with a completely rubber covered outer diameter and a secondary dust lip which protects the other lip against dust and other fine contaminants. This type of radial oil seal is recommended for use in polluted environments.

Temporarily out of stock

Installation Dimensions:

Shaft diameter, d1 h11
160.0  mm
Bore diameter, d2 H8
190.0  mm
Width, b
15.0  mm

Material Properties:

Tensile Strength
9.1  MPa
Hardness Nominal
Hardness Tolerance
+/- 5  
Hardness Unit
Shore A  

Quality & Norms:

Correspond to the recommendation in DIN 3760
installation drawing table

Material Information for the product(s) on this page TREA01600-VCV


Basic Material
Commercial Description
A 75 durometer FKM with a standard steel case. Comes with a stainless steel spring. FKM is an elastomer material known especially for its non-flammability, low gas permeability and excellent resistance to ozone, weathering, and ageing.  The operating temperatures of the fluorocarbon rubber range between -20 °C and +200 °C.  FKM is also often used with mineral based oils and greases at high temperatures.